Only $20.18 | Cisco 200-125 study guide

What are you waiting for? Opportunity knocks but once. You can get Cisco 200-125 complete as long as you enter Passtcert website. You find the best Cisco 200-125 study guide, with our exam questions and answers, you will pass the exam.Passtcert is a convenient website to provide service for many of the candidates participating in the IT certification exams. A lot of candidates who choose to use the Passtcert 200-125 CCNA Cisco Certified Network Associate CCNA (v3.0) have passed IT certification exams for only one time.

Dreams and hopes are important, but more important is to go to practice and prove. The Passtcert Cisco 200-125 study guide will be successful, select it, you have no reason unsuccessful! The society has an abundance of capable people and there is a keen competition. Don’t you feel a lot of pressure? No matter how high your qualifications, it does not mean your strength forever. Not to mention that Passtcert Cisco 200-125 study guide are many candidates proved in practice. It brings the success of each candidate is also real and effective.


Share some CCNA Routing and Switching 200-125 exam questions and answers below.
Which two statements about late collisions are true? (Choose two.)

A. They may indicate a duplex mismatch.

B. By definition, they occur after the 512th bit of the frame has been transmitted.

C. They indicate received frames that did not pass the FCS match.

D. They are frames that exceed 1518 bytes.

E. They occur when CRC errors and interference occur on the cable.

Answer: AB

A network administrator needs to configure a serial link between the main office and a remote location. The router at the remote office is a non-cisco router.

How should the network administrator configure the serial interface of the main office router to make the connection?

A. Main(config)#interface serial 0/0

Main(config-if)#ip address 172.16.1.1 255.255.255.252

Main(config-if)#no shut

B. Main(config)#interface serial 0/0

Main(config-if)#ip address 172.16.1.1 255.255.255.252

Main(config-if)#encapsulation ietf

Main(config-if)#no shut

C. Main(config)#interface serial 0/0

Main(config-if)#ip address 172.16.1.1 255.255.255.252

Main(config-if)#encapsulation frame-relay

Main(config-if)#authenication chap

Main(config-if)#no shut

D. Main(config)#interface serial 0/0

Main(config-if)#ip address 172.16.1.1 255.255.255.252

Main(config-if)#encapsulation ppp

Main(config-if)#no shut

Answer: D

Which command would you configure globally on a Cisco router that would allow you to view directly connected Cisco devices?

A. R(config-if)#cdp run

B. R(config-if)#cdp enable

C. R(config)#cdp run

D. R(config)#cdp enable

Answer: C

If you are configuring syslog messages specifying `logging trap warning’, which log messages will the router send?

A. 0-4

B. 0-5

C. 0-6

D. 0-2

E. 0-1

Answer: A

How to create a trunk port and allow VLAN 20? (Choose Three.)

A. switchport trunk encapsulation dot1q

B. switchport mode trunk

C. switchport trunk allowed vlan 20

D. switchport trunk native vlan 20

Answer: ABC

What is the difference between a CSU/DSU and a modem?

A. A CSU/DSU converts analog signals from a router to a leased line; a modem converts analog signals from a router to a leased line.

B. A CSU/DSU converts analog signals from a router to a phone line; a modem converts digital signals from a router to a leased line.

C. A CSU/DSU converts digital signals from a router to a phone line; a modem converts analog signals from a router to a phone line.

D. A CSU/DSU converts digital signals from a router to a leased line; a modem converts digital signals from a router to a phone line.

Answer: D

What will be the result if the following configuration commands are implemented on a Cisco switch?

Switch(config-if)# switchport port-security

Switch(config-if)# switchport port-security mac-address sticky

A. A dynamically learned MAC address is saved in the startup-configuration file.

B. A dynamically learned MAC address is saved in the running-configuration file.

C. A dynamically learned MAC address is saved in the VLAN database.

D. Statically configured MAC addresses are saved in the startup-configuration file if frames from that address are received.

E. Statically configured MAC addresses are saved in the running-configuration file if frames from that address are received.

Answer: B

Passtcert promise that we will spare no effort to help you pass Cisco certification 200-125 exam. Now you can free download part of Cisco 200-125 study guide on Passtcert. When you select Passtcert, you can not only pass CCNA Routing and Switching certification 200-125 exam, but also have one year free update service. Passtcert can also promise if you fail to pass the exam, Passtcert will 100% refund.

Leave a Reply

Your email address will not be published. Required fields are marked *

*